Glue Experiment

Results of my initial glue tests were as follows:

Gorilla Glue - Worked well, bonded tight easy to clean-up but I get the feeling that if I pulled with some pliers hard I might be able to separate the pieces.

Gorilla Glue 2 Part Epoxy - This epoxy did not mix as well coming out of the tubes and did not bound very well.

Amazing Goop - This worked very well, however it was hard to cleanup the run over.

Permatex 84101 General Purpose Epoxy - This did not bond to the white material at all.

I think what I am going to do to re-secure #9, #11, #11a, #11b is use the goop on the center of the components and the gorilla glue on the near the outside of the pieces. This way the cleanup will be a lot easier.